Removing The Rear Vga Port - Dell EMC XC Core XC650 Installation And Service Manual

Figure 88. Installing the VGA module
Next steps
1. Route the VGA cable, close the cable latch, and connect the VGA cable to the connector on the system board.
2. Route and connect the right control panel cable.
3. If removed, install the air
4. Install the backplane cover.
5. If installed, Install the front
6. Follow the procedure listed in the

Removing the rear VGA port

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove expansion card riser
Steps
1. Disconnect the VGA port cable from the video connector on the rear I/O board and open the latch on the expansion card
riser.
2. Slide the VGA port out of the expansion card riser.
shroud.
bezel.
After working inside your
Safety instructions.
Before working inside your
3.
system.
system.
Installing and removing system components 99