Rear Mounting Front Perc Module; Removing The Front Mounting Front Perc Module - Dell EMC XC Core XC650 Installation And Service Manual

Figure 32. Installing the drive backplane
3. Route the cables properly through the cable guide and connect the cables to the connector on the system board. Tighten
the captive screw on the cable guiding latch.
Next steps
1. Install all of the drives.
2. If removed, install the air
3. Install the drive backplane
4. Follow the procedure listed in

Rear mounting front PERC module

Removing the front mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive backplane
4. If installed, remove the air
5. Disconnect the SAS cable from PERC, observe the cable routing.
44 Installing and removing system components
shroud.
cover.
After working inside your
Safety instructions.
Before working inside your
cover.
shroud.
system.
system.