Table of Contents
Advertisement
Figure 64. Installing the expansion card riser (Riser 4)
Next steps
1. If required, re-connect the cables to the expansion card.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If applicable, disconnect the cables from the expansion card.
Steps
1. Pull and lift the expansion card retention latch lock to open.
NOTE:
Pull the card holder before removing the card from the riser.
2. Hold the expansion card by the edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
77
Advertisement
Table of Contents
