Table of Contents
Advertisement
Figure 84. Installing the OCP card
Next steps
1.
Install the expansion card
2. Follow the procedure listed in
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery
only with the same or equivalent type That is recommended by the manufacturer. Discard used batteries
according to the manufacturer's instructions. See the Safety instructions. that came with your system for more
information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If applicable, disconnect the power or data cables from the expansion cards.
4.
Remove the expansion card
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
94
Installing and removing system components
riser.
After working inside your
Safety
instructions.
Before working inside your
risers.
system.
system.
Advertisement
Table of Contents
