Table of Contents
Advertisement
Figure 31. Removing the drive backplane
Next steps
1.
Replace the drive
backplane.
Installing the drive backplane
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If installed,
remove the air
4.
Remove the drive backplane
5.
Remove all of the
drives.
NOTE:
To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before
removing the backplane.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Use the guides on the system to align the slots on the backplane.
2. Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Safety
instructions.
Before working inside your
shroud.
cover.
system.
Installing and removing system components
43
Advertisement
Table of Contents
