7. Help
Display
No display
Try recharging or replacing the battery pack.
Reset the units. Disconnect the battery pack of the parent unit and
unplug both the units' electrical power, then plug them back in.
Is the unit turned on?
Press and hold the ON/OFF key on the parent unit to turn it ON.
Is the correct camera selected?
Change the camera number, if necessary.
Is the video display turned on?
Press the VIDEO ON/OFF key to turn it on.
When operating using batteries, only the Display will go blank after
2 minutes to save power. The unit is still active and will give you
audio alerts. You can reactivate the screen by pressing any key.
Registration
If the Indoor/Outdoor Camera has lost its link with the
Parent Unit
Try recharging or replacing the battery pack.
If the Indoor/Outdoor Camera is too far away it may be going out
of range, so move the Camera closer to the Parent Unit.
Reset the units by disconnecting them from the battery and
electrical power. Wait about 15 seconds before reconnecting.
Allow up to one minute for the Indoor/Outdoor Camera and the
Parent Unit to synchronize.
See 2.4 Registration (Pairing), if there is a need to re-register the
units.
24
Help