Switching The Server On And Off - Fujitsu PRIMERGY RX200 S5 Operating Manual

Starting up and operation
5.2

Switching the server on and off

V
CAUTION!
If nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see section
stripes on monitor screen" on page
The On/Off button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug(s).
Switching the server on
The power-on indicator (item 10 in
– Starting up for the first time:
Ê Press the On/Off button (item 11 in
The Power-on indicator (item 10 in figure
Ê Insert the ServerView Suite DVD 1 into the DVD drive.
Ê Follow the on-screen instructions (see also section
server and installing the operating system with the ServerView
Installation Manager" on page 68
installing the operating system without ServerView Installation Manager"
on page 69).
– System already installed:
Ê Press the On/Off button (item 5 in figure
Power-on indicator (item 6 in figure
The server is switched on, performs a system test and boots the
operating system.
RX200 S5
Switching the server on and off
75).
figure 12 on page
figure 12 on page
12 on page
or section
12 on page
12 on page
Operating Manual
"Flickering
55) lights orange.
55).
55) lights up green.
"Configuring the
"Configuring the server and
55).
55) lights green.
65