Fujitsu PRIMERGY RX200 S5 Operating Manual page 104

Replacement of non-hot-plug components
Installing an expansion card
Figure 37: Riser card holder equipped with a controller
Ê Insert the expansion card in the slot of the riser card.
I
Make sure that the rear cover fits into the correct notch (see circle).
Ê If necessary, connect the cable to the expansion card and the other
components.
Reinstalling the riser card holders
Ê Position the riser card holder over the relevant slot on the system board.
Ê Carefully push the riser card holder into the slot by pressing on the green
points ("touch points").
Ê Close the server (see
power plugs to the power outlets and switch on the server.
104
section "Closing the server" on page
Operating Manual
CSS components
105), connect all
RX200 S5