Boot; This Section Configures Boot Options; Exit - DFI BPC 420-BW User Manual

Boot

This section configures boot options.

InsydeH20 Setup Utility
Main Advanced Security Boot
OS Selection <Windows>
Numlock <On>
Boot Type <Legacy Boot Type>
PXE Boot to LAN <Disabled>
USB Boot <Enabled>
F1 Help ↑/↓ Select Item F5/F6
Esc

Exit

←/→ Select Item Enter
OS Selection
Select the system's operating system: Windows, Linux or DOS
Numlock
Select the power-on state for the numlock key
Boot Type
Select the boot type. The options are Dual Boot Type, Legacy Boot Type or UEFI
Boot Type.
PXE Boot Capability or PXE Boot to LAN
Disables or enables Preboot eXecution Environment (PXE) boot to LAN (if Boot
Type selected is legacy) or PXE Boot Capability (if Boot Type selected is UEFI).
Network Stack
Enable or disable network stack in UEFI mode. This option will be shown only if
the PXE Boot Capability is enabled.
USB Boot
Enable or disable the booting to USB boot devices.
Chapter 3 BIOS Setup
Chapter 7 BIOS Setup
Rev. 5.0
Exit
Selects Power-on state for
Numlock
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

.
.
Chapter 7
Exit
This section configures the parameters for exiting the BIOS menu.
Main Advanced
Exit Saving Changes
Load Optimal Defaults
Discard Changes
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
Exit Saving Changes
Select this field and then press <Enter> to exit the system setup and save your changes.
Load Optimal Defaults
Select this field and then press <Enter> to load optimal defaults.
Discard Changes
Select this field and then press <Enter>to exit the setup utility without saving your changes.
38
InsydeH20 Setup Utility
Security Boot Exit
Exit system setup and save
your changes.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Rev. 5.0
www.dfi.com