DFI BPC 420-BW User Manual page 35

ME Configuration
This section configures settings of flashing the Intel
InsydeH20 Setup Utility
Advanced
ME Configuration
Me Fw Image Re-Flash <Disabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
Me Fw Image Re-Flash
Enable or disable flashing of the Intel
Chapter 3 BIOS Setup
Chapter 7 BIOS Setup
® Management Engine firmware.
Rev. 5.0
Me Fw Image Re-Flash
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Management Engine firmware.
®
Chapter 7
Super IO (SIO) Configuration
This section configures the system's super I/O chip parameters.
Advanced
COM Port 1
Base I/O Address
Interrupt
Type
COM Port 2
Base I/O Address
Interrupt
Type
COM Port 3
Base I/O Address
Interrupt
COM Port 4
Base I/O Address
Interrupt
WDT
Case Open
AC Power Loss
PC Health Status

Smart Fan Function

F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
Serial Port 1 to Serial Port 4
Configure the settings of each serial port.
• Disable: Disable this serial port.
• Enable: Enable this serial port.
Type
Choose RS232/RS422/RS485 (Peer-to-Peer) for the serial port type for COM port 1 and
COM port 2.
35
InsydeH20 Setup Utility Rev. 5.0
<Enable> Configure Serial port using
<3F8> options: [Disable] No Con-
<IRQ4> figuration [Enable] User
<RS232> Configuration [Auto] EFI/
<Enable> OS chooses configuration
<2F8>
<IRQ3>
<RS232>
<Enable>
<3E8>
<IRQ4>
<Enable>
<2E8>
<IRQ3>
<Disable>
<Disable>
<Always off>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi.com