DFI BPC 420-BW User Manual page 33

SATA Configuration
This section configures the SATA controller.
InsydeH20 Setup Utility
Advanced
SATA Configuration
SATA Controller <Enabled>
HDC Configure As <AHCI>
 Serial ATA Port 0 [Not Installed]
 Serial ATA Port 1 [Not Installed]
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
SATA Controller
Enable or disable the Serial ATA controller(s).
HDC Configure As
The mode selection determines how the SATA controller(s) operates.
AHCI Mode
This option allows the serial ATA devices to use AHCI (Advanced Host Control-
ler Interface).
Serial ATA Port 0, and 1
Enable or disable the SATA port:
SATA Port 0 controls SATA Port 0.
SATA Port 1 controls the full-size Mini PCIe slot (mSATA).
Chapter 3 BIOS Setup
Chapter 7 BIOS Setup
Chapter 7
Rev. 5.0
DISABLED: Disables
SATA Controller
ENABLED: Enables SATA
Controller
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

USB Configuration
This configures the parameters of the USB 3.0 xHCI (eXtensible Host Controller Interface).
Advanced
USB Configuration
USB3.0 Support <Enabled>
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
USB3.0 Support
Disabled
Disable USB XHCI Pre-Boot Support.
Enabled
Enable USB XHCI Pre-Boot Support.
33
InsydeH20 Setup Utility Rev. 5.0
Enable/Disable the USB
XHCI PreBoot Support
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi.com