Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Wrench tighten ALL hardware at the end until the
last step. Some components may be pre-assembled.
1A. Attach Dumbbell Holder Frame A (A) to Side Covers (C) using:
6 - (#1) M8x20mm Button Head Cap Screw
12 - (#3) M8 Flat Washer
6 - (#5) M8 Nylon Lock Nut
1B. Attach Dumbbell Holder Frames B (B) to the Side Covers (C) using:
12 - (#1) M8x20mm Button Head Cap Screw
24 - (#3) M8 Flat Washer
12 - (#5) M8 Nylon Lock Nut
Note: Make sure the Dumbbell Rack sits flat on the floor when tightenning
all hardware.
8
Advertisement
