Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 1B. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
1A. Attach Uprights (B) to Base Frame (A) using:
4 - (#1) M10x70mm Hex Head Bolt
8 - (#4) M10 Flat Washer
4 - (#5) M10 Nylon Lock Nut
2 - (D) STEEL PLATE
1B. Attach Uprights (B) to Logo Plate (C) using:
4 - (#1) M10x70mm Flat Head Cap Screw
4 - (#4) M10 Flat Washer
4 - (#5) M10 Nylon Lock Nut
8
Advertisement
