Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Insert Telescoping Base Frames (A) into the open ends of the Main
Base Frames (E).
1B. Attach Rear Uprights (B), Telescoping Base Frames (A) and Main
Base Frames (E) together using:
8 - (#2) M16x110mm Hex Head Bolt
16 - (#3) M16 Flat Washer
8 - (#4) M12 Nylon Lock Nut
4 - (G) Steel Plate
NOTE:
Please refer to the drawing for the correct bolt hole locations.
8
Advertisement
