Advertisement
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Wrench tighten ALL hardware at the end until the
last step. Some components may be pre-assembled.
2A. Attach Foot Plate (D) to Side Cover (C) using:
2 - (#1) M8x20mm Button Head Cap Screw
4 - (#3) M8 Flat Washer
2 - (#5) M8 Nylon Lock Nut
Note: Make sure the Foot Plate is installed on the opposite side of Dumbbell
Holder Frame A.
2B. Attach Top Cap(E) to Side Covers (C) using:
3 - (#2) M3.9x10mm Pan Head Phillips Screw
10
Advertisement
