Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 1B. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
1A. Attach Bottom Tray (A) to Uprights (C, D, E) using:
5 - (#1) M8x45mm Socket Head Cap Screw
5 - (#2) M8 Flat Washer
5 - (#3) M8 Barrel Nut
1B. Attach three Trays (B) to Uprights (C, D, E) using:
1
5 - (#1) M8x45mm Socket Head Cap Screw
15 - (#2) M8 Flat Washer
15 - (#3) M8 Barrel Nut
8
Advertisement
