Installing The M.2 Ssd Module; Processor And Heat Sink; Removing The Heat Sink - Dell E80S Series Installation And Service Manual

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the BOSS S1
NOTE: The procedure to remove the BOSS S1 card is similar to the removing an expansion card.
Steps
1. Align the M.2 SSD module at an angle with the BOSS S1 card connector.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS S1 card connector.
3. Using the Phillips 1 screwdriver, secure the M.2 SSD module on the BOSS S1 card with the screw.
Figure 42. Installing the M.2 SSD module
Next steps
1. Install the BOSS S1 card
NOTE: The procedure to install the BOSS S1 card is similar to installing an expansion card.
2. Follow the procedure listed in

Processor and heat sink

This is a service technician replaceable part only.

Removing the heat sink

Prerequisites
WARNING: The heat sink may be hot to touch for some time after the system has been powered off. Allow the
heat sink to cool before removing it.
52 Installing and removing system components
Safety
Before working inside your
card.
After working inside your
instructions.
system.
system.