Table of Contents
Advertisement
Video Input
Input Source Selection (Component, RGB Scart 21-Pin)
Direct Operation
Choose Computer 2 by pressing the INPUT button on the top
control or press the COMPUTER button on the remote control.
Before using these buttons, correct input source should be
selected through menu operation as described below.
Menu Operation
1
Press the MENU button and the On-Screen Menu will
appear. Press the Point
pointer to the Input Menu icon.
2
Press the Point
Computer 2, and then press the SELECT button. The Source
Select Menu will appear.
3
Move the pointer to the correct input source and then press
the SELECT button.
When the input source is coming from video
Component
equipment connected to the COMPUTER IN 2/
COMPONENT IN/ MONITOR OUT terminal with
a Component-VGA Cable, select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the COMPUTER IN 2/
COMPONENT IN/ MONITOR OUT terminal with
a Scart-VGA Cable, select RGB (Scart).
✔
Note:
• Component-VGA Cable and Scart-VGA Cable are optionally supplied. See page 61
for order.
• Computer 2 is not displayed when the COMPUTER IN 2/COMPONENT IN/
MONITOR OUT terminal is set as Monitor out. (p44)
36
7 8
buttons to move the red frame
d d
button to move the red arrow pointer to
TOP CONTROL
POWE
INPUT button
INPUT
AUTO SET UP
SELECT
MENU
REMOTE CONTROL
COMPUTER button
COMPUTER button
✳ See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
Computer
2
Source Select Menu
Move the pointer to
Component or RGB (Scart)
and press the SELECT
button.
INPUT button
Computer 1
✳
Computer 2
Video
Computer 1
✳
Computer 2
Advertisement
Table of Contents
