Table of Contents
Advertisement
Video Input
Input Source Selection (Video, S-Video)
Direct Operation
Choose Video by pressing the INPUT button on the top control or
the VIDEO button on the remote control.
Before using these buttons, correct input source should be
selected through menu operation as described below.
Menu Operation
1
Press the MENU button and the On-Screen Menu will
appear. Press the Point
pointer to the Input Menu icon.
2
Press the Point
Video and then press the SELECT button. The Source Select
Menu will appear.
3
Move the pointer to the source that you want to select and
then press the SELECT button.
When selecting Auto, the projector automatically
Auto
detects incoming video signal, and adjusts itself to
optimize its performance.
✔
Note:
The projector selects the input source in the
•
following priority.
1. S-video
2. Video
When video input signal is connected to the VIDEO
Video
jack, select Video.
When video input signal is connected to the S-VIDEO
S-Video
jack, select S-Video.
✔
Note:
When Monitor out is selected at the Terminal item in the Setting Menu, Computer 2 is
not displayed. (p44)
7 8
buttons to move the red frame
d d
button to move the red arrow pointer to
TOP CONTROL
POWE
INPUT button
INPUT
AUTO SET UP
SELECT
MENU
REMOTE CONTROL
VIDEO button
✳ See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer to Video
and press the SELECT
button.
VIDEO
Source Select Menu (VIDEO)
Move the pointer to the
source that you want to
select
SELECT button.
INPUT button
Video
Computer 1
✳
Computer 2
and
press
the
35
Advertisement
Table of Contents
