Input Source Selection (Component, Rgb Scart 21-Pin) 6 - Eiki LC-XB31 Owner's Manual

Video Input
Input Source Selection (Component, RGB Scart 21-pin)
Direct Operation
Choose Computer 1 by pressing the INPUT button on
the top control or press the COMPUTER button on the
remote control.
Before using these buttons, correct input source should
be selected through Menu operation as described
below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Press the Point
red framed pointer to the Input Menu icon.
2
Press the Point
ed
pointer to Computer 1 and then press the SELECT
button.
3
After the Source Select Menu appeared for
Computer 1, move the pointer to Component or
RGB (Scart) and then press the SELECT button.
When the input source is coming from
Component
video equipment connected to the
COMPUTER IN 1/COMPONENT IN
terminal with a Component-VGA Cable
(not supplied), select Component.
When the input source is coming from
RGB (Scart)
video equipment connected to the
COMPUTER IN 1/COMPONENT IN
terminal with a Scart-VGA Cable(not
supplied), select RGB (Scart).
Note:
✔
• When the Input Search function is set On1 or On,
the input signal will be searched automatically
(p.46)
• C o m p u t e r  i s n o t d i s p l a y e d w h e n t h e
COMPUTER IN /MONITOR OUT terminal is set
as Monitor out. (p.47)
36
buttons to move the
7 8
buttons to move the red arrow
Top Control
INPUT button
INPUT button
Remote Control
COMPUTER button
COMPUTER button
✳ See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Computer
1
Source Select Menu
Move the pointer to
Component or RGB(Scart)
and press the SELECT
button.
Computer 1
Computer 2
✳
Video
Computer 1
Computer 2
✳