Lamp Replacement - Eiki LC-XB30 Owner's Manual

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an
end, the LAMP REPLACE indicator emits yellow light. If this
indicator emits yellow light, replace the lamp with a new one
promptly.
CAUTION
Allow the projector to cool, for at least 45 minutes
before you open the Lamp cover. The inside of the
projector can become very hot.
Follow these steps to replace the lamp.
1
Turn off the projector and disconnect the AC power cord.
Allow the projector to cool for at least 45 minutes.
2 Loosen the screw with a screwdriver, and remove the lamp
cover.
3
Loosen 2 screws of the lamp with a screwdriver and pull out
the lamp by grasping the handle.
4 Replace the lamp with a new one and tighten the 2 screws
back into position. Make sure that the lamp is set properly.
Replace the lamp cover and tighten the screw.
5 Connect the AC power cord to the projector and turn on the
projector.
6 Reset the Lamp replace counter.
See "Lamp Replace Counter" on the next page .
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
●
Model No. of your projector
●
Replacement Lamp Type No.
52
This indicator emits yellow
light when the life of the
projection lamp draws to an
end.
CAUTION
For continued safety, replace with a lamp of the same
type. Do not drop the lamp or touch the glass bulb! The
glass can shatter and may cause injury.
Lamp Cover
Lamp
Screw
: LC-XB30
: POA-LMP55
(Service Parts No. 610 309 2706)
Top Control
POWER
WARNING
LAMP
REPLACE
SELECT
Screw
Screw
Handle