Connecting The Ac Power Cord - Eiki LC-XB30 Owner's Manual

Installation

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-120 V or 200-240
V AC. This projector automatically selects the correct input
voltage. It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce risk of electrical
shock, do not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of the type of power being supplied.
Connect the projector with all peripheral equipment before turning
the projector on. (See page 17-19 for connection.)
CAUTION
For safety, unplug the AC power cord when the projector is not
in use. When this projector is connected to an outlet with the
AC power cord, it is in Stand-by mode and consumes a little
electric power.
NOTE ON THE POWER CORD
The AC Power Cord must meet the requirement of the country where you use the projector.
Confirm the AC plug type with the chart below. The proper AC Power Cord must be used.
If the supplied the AC Power Cord does not match the AC outlet, contact your sales dealer.
Projector side
16
For the U.S.A. and Canada
To the POWER CORD
CONNECTOR on the
projector.
Connect the AC power cord (supplied) to the
projector.
The AC outlet must be near this equipment and
must be easily accessible.
AC Outlet side
For Continental Europe
Ground
To the AC Outlet.
(120 V AC)
To the AC Outlet.
(200 - 240 V AC)