Connecting The Power Cord; Connecting The Power Cord For The Lsvm1Ac300 Power Module - H3C S5800-EI Series Installation Manual

Grasping the handle of the power module with one hand and using the thumb to press the latch
4.
towards the handle, pull the power module at the same time. After pulling the power module
part-way out, hold the bottom of the power module with the other hand, and pull the power
module slowly out of the slot along the guide rails.
Keep the removed power module in an antistatic bag or the power module package bag for
future use.
If you are not to install a power module, install the filler panel in the slot to prevent dust and
5.
ensure good ventilation.

Connecting the power cord

CAUTION:
• Provide a circuit breaker for each power cord.
• Before connecting a power cord, make sure the circuit breaker on the power cord is turned off.
Connect the LSVM1AC300 power module to the AC power source. Connect the LSVM1DC300
power module to the –48 VDC power source.
Connecting the power cord for the LSVM1AC300 power
module
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Connect the female connector of the AC power cord to the AC input socket on the power
2.
module.
Figure 22 Connecting the AC power cord to the LSVM1AC300 power module
Use a cable tie to secure the AC power cord to the handle of the power module.
3.
17