H3C S5800-EI Series Installation Manual page 27

b. Gently push the expansion card into the slot along the guide rails until the expansion card
has good contact with the chassis. See callout 2 in
c. Rotate in the ejector lever, as shown by callout 3 in
d. Use a Phillips screwdriver to tighten the captive screw on the expansion card to secure it in
the slot. See callout 4 in
If the expansion card does not have an ejector lever, follow these steps to install it:
5.
a. Gently push the expansion card into the slot along the guide rails until the expansion card
has good contact with the chassis. See callout 1
b. Use a Phillips screwdriver to tighten the captive screw on the expansion card to secure it in
the slot. See callout 2
Figure 27 Installing an expansion card with an ejector lever (LSWM2QP2P)
Figure 28 Installing an expansion card without an ejector lever (LSWM2XGT8PM)
Figure 27.
Figure 28.
20
Figure 27.
Figure 27.
Figure 28.