Connecting The Power Cord For The Lsvm1Dc300 Power Module - H3C S5800-EI Series Installation Manual

Figure 23 Securing the AC power cord with a cable tie (1)
Figure 24 Securing the AC power cord with a cable tie (2)
Connect the other end of the power cord to an AC power source and turn on the circuit breaker.
4.
Connecting the power cord for the LSVM1DC300 power
module
WARNING!
• H3C DC power cords are required if the –48 VDC power source is used.
• Identify the positive (+) and negative (-) marks on the two wires to avoid connection mistakes.
To connect the power cord for the LSVM1DC300 power module:
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Correctly orient the female connector of the cable with the power receptacle on the power
2.
module, and insert the connector into the power receptacle. See callout 1 in
If you cannot insert the connector into the receptacle, re-orient the connector rather than use
excessive force to push it in.
Use a cable tie to secure the DC power cord to the handle on the power module.
3.
Connect the other end of the power cord to a –48 VDC power source.
4.
18
Figure 25.