S5800-56C-Ei/S5800-56C-Ei-M - H3C S5800-EI Series Installation Manual

S5800-56C-EI/S5800-56C-EI-M

Figure 43 S5800-56C-EI/S5800-56C-EI-M front panel
(1) 10/100/1000BASE-T autosensing Ethernet
port
(3) Management Ethernet port
(5) Serial console port (CONSOLE)
(7) LED for the port LED mode (MODE)
(9) Port LED mode switching button
(11) Expansion slot 2 LED (SLOT2)
(13) Power module slot 2 LED (PWR2)
(15) SFP+ port LED
Figure 44 S5800-56C-EI/S5800-56C-EI-M rear panel
(1) Grounding screw
(3) Fan tray 1
(5) Fan tray 2
(7) Power module 2
The S5800-56C-EI and S5800-56C-EI-M switches each comes with power module slot 1 (PWR1)
empty and power module slot 2 (PWR2) installed with a filler panel. You can install one or two power
modules for the switch as required. In
in the power module slots. For more information about installing and removing a power module, see
"Installing/removing a power
(2) 10/100/1000BASE-T autosensing Ethernet port
LED
(4) Management Ethernet port LED (ACT/LINK)
(6) Mini USB console port
(8) USB port
(10) System status LED (SYS)
(12) Expansion slot 1 LED (SLOT1)
(14) Power module slot 1 LED (PWR1)
(16) SFP+ port
Figure 44, two LSVM1AC300 AC power modules are installed
module."
38
(2) Expansion card 1
(4) Expansion card 2
(6) Power module 1