Table of Contents
Advertisement
Mounting the motor
5.6 Notes on laying cables in drag chains
To ensure a long service life of the drag chain and cable, lay cables made of different
materials separately with separating webs in the drag chain.
• Fill the webs evenly to ensure that the position of cables does not change during
operation.
• Distribute cables as symmetrically as possible according to their weights and dimensions.
• Use webs to separate cables with different outer diameters.
• Keep cables untwisted in the drag chain.
Moving cables
• Cables must be able to move without constraint, especially in the bending radii of the
chain.
• Observe the specified minimum bending radii.
R: Bending radius on the drag chains
Fixing cables
• Make sure that cables in the drag chain are unattached and movable.
• Place the cable fixture in a "dead" zone at each end, suitably far away from each end point
of the moving parts.
72
Equipment Manual, 01/2021, A5E43087278-004
1PH3 main motors
Advertisement
Table of Contents
