Checking Enclosure Status In Easm - Edge10 EDGESTORE NAS400 User Manual

EdgeStore NAS400 User Manual
Reported Event
Migration or Rebuilding
on array X paused at Y%.
Migration or Rebuilding
on array X resumed at
Y%.
Migration or Rebuilding
on array X completed.
Migration or Rebuilding
on array X aborted at Y%
Migration or Rebuilding
on array X aborted at Y%
because of error.
RAID status: "OFFLINE".
The NAS400 X volume Y
is offline.
RAID status: "CRITICAL".
The NAS400 X volume Y
is not functioning
correctly.
RAID X had some errors.
Formatting was aborted!

Checking Enclosure Status in EASM

To check Enclosure status:
1. Start EASM.
See "EASM in your Browser" on page 60.
Or see "EASM in SmartSYNC" on page 61.
2. In the Tree, click the + beside the System icon.
3. Click the System Information icon.
4. Click the Enclosure Information tab.
See Figure 5.
RAID Volume Migration or Rebuild was paused
temporarily by user action.
RAID Volume Migration or Rebuild was paused and
then resumed by user action.
RAID Volume Migration or Rebuild has finished.
Normal.
RAID Volume Migration or Rebuild was aborted
(stopped) by user action.
RAID Volume Migration or Rebuild has aborted
(stopped) because of an error. Check the disk drives.
See page 112. Check the RAID Volume. See
page 113.
Check the disk drives. See page 112. Replace the
failed drive. See page 113. Create a new RAID
Volume. See page 80.
Check the disk drives. See page 112. Replace the
failed drive. See page 113. The RAID Volume will
rebuild automatically.
Check the disk drives. See page 112. Replace the
failed drive. See page 113.
120
Corrective Action