Optional Scu-30 Wireless Access Point Installation; Initial Setup Required When Turning On; The Power For The First Time; Maritime Mobile Service Identity (Mmsi) - Standard Horizon GX2400GPS Owner's Manual

8.5.9 Optional SCU-30 Wireless Access Point Installation

To connect the SSM-72H (RAM4X), the SCU-30 firmware must be Ver.
2.00.00 or later.
The GX2400 is capable of using a SSM-72H (RAM4X) Wireless Remote Station
Microphone to remotely control the Radio, AIS, DSC and PA/Fog functions. In
addition the GX2400 can operate as a full function intercom system between
the RAM4X and the GX2400.
The optional SCU-30 Wireless Access Point, may be utilized to connect up to
four RAM4X Wireless Remote Access Microphones to the GX2400.
Do not connect or remove the SCU-30 Wireless Access Point while the
radio is powered ON. This could result in damage to the equipment.
1. Connect the SCU-30 Cable to the RAM Connector on the GX2400 rear
panel, and tighten the cable nut.
NOTE: For additional details on the connecting the RAM4X and GX2400, refer to
the RAM4X Instruction Manual.
8.6 INITIAL SETUP REQUIRED WHEN TURNING ON THE
POWER FOR THE FIRST TIME

8.6.1 Maritime Mobile Service Identity (MMSI)

What is an MMSI?
An MMSI is a nine-digit number used on marine transceivers capable of using
Digital Selective Calling (DSC) signal transmission. This number is used like
a telephone number to selectively call other vessels.
THIS NUMBER MUST BE PROGRAMMED INTO THE RADIO TO OPERATE
DSC FUNCTIONS.
How can I obtain an MMSI assignment?
Contact the Radio Licensing Authority for your country for information on obtaining an
MMSI number.
24
NOTE
WARNING