Optional Serial Com Port; Removing The Serial Com Port - Dell EMC PowerEdge R6525 Installation And Service Manual

NOTE: Push the black card holder to hold the card in the riser.
Figure 97. Closing the card holder on the expansion card riser
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.

Optional serial COM port

Removing the serial COM port

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Lift the expansion card riser
2. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety instructions.
Before working inside your
and disconnect the serial COM port cable from the connector on the rear I/O board.
system.
system.
Installing and removing system components 113