Table of Contents
Advertisement
Figure 130. Installing the system board
Next steps
1. Replace the following components:
a.
Trusted Platform Module (TPM)
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
IDSDM module (if installed)
c.
Internal USB card (if installed)
d.
Power supply units (PSU)
e.
OCP card (if installed)
f.
Processor
g.
Heat sink
h.
Memory modules
i.
Cooling fan modules
j.
Air shroud (if installed)
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature
section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag by using System Setup
c. Update the BIOS and iDRAC versions.
Reenable the Trusted Platform Module (TPM). See the
4. If you are not using Easy restore, import your new or existing iDRAC Enterprise license. For more information, see the iDRAC
User's Guide available at
5. Follow the procedure listed in
https://www.dell.com/idracmanuals
After working inside your
Restoring the system by using the Easy Restore
section.
Upgrading the Trusted Platform Module
.
system.
Installing and removing system components
Manually
section.
143
Advertisement
Table of Contents
