Table of Contents
Advertisement
Figure 117. Installing the BOSS S2 card carrier
Next steps
1. Follow the procedure listed in the
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery
only with the same or equivalent type That is recommended by the manufacturer. Discard used batteries
according to the manufacturer's instructions. See the Safety instructions. that came with your system for more
information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the power or data cables from the expansion cards.
4.
Remove the expansion card
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
After working inside your
Safety
instructions.
Before working inside your
risers.
system.
system.
Installing and removing system components
129
Advertisement
Table of Contents
