Removing The Drive From The Drive Carrier - Dell EMC PowerEdge R6525 Installation And Service Manual

NOTE: Ensure that the drive carrier's release handle is in the open position before inserting the carrier into the slot.
1. Follow the safety guidelines listed in the
2. If installed, remove the front
3. Remove the drive carrier or remove the drive blank when you want to assemble the drives in to the system.
Steps
1. Slide the drive carrier into the drive slot.
2. Close the drive carrier release handle to lock the drive in place.
Figure 36. Installing a drive carrier
Next steps
If removed, install the front

Removing the drive from the drive carrier

Prerequisites
1. Follow the safety guidelines listed in the
2. If installed, remove the front
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to remove the drive.
46 Installing and removing system components
Safety instructions.
bezel.
bezel.
Safety instructions.
bezel.