Figure 132. Installing the LOM card and rear I/O board
Next steps
1.
Install the system
board.
2. Follow the procedure listed in
RIO card
Removing the Rear Input Output (RIO) card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the RIO card to the system board.
2. Holding the edges, pull the RIO card to disconnect from the connector on the system board.
146
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.