Table of Contents
Advertisement
Chapter 6: UEFI BIOS
Above 4G MMIO BIOS Assignment
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Enabled and Disabled.
VGA Priority
Use this feature to select VGA priority when multiple VGA devices are detected. Select
Onboard to give priority to your onboard video device. Select Offboard to give priority to your
graphics card. The options are Onboard and Offboard.
NVMe Firmware Source
Use this feature to select the NVMe firmware to support booting. The options are Vendor
Defined Firmware and AMI Native Support. The default option, Vendor Defined Firmware,
is pre-installed on the drive and may resolve errata or enable innovative functions for the
drive. The other option, AMI Native Support, is offered by the BIOS with a generic method.
PCIe/PCI/PnP Configuration
CPU MICRO-LP PCIE 3.0 X8 OPROM
Use this feature to select which firmware to be loaded for the add-on card in this slot. The
options are Disabled, Legacy, and EFI.
CPU SLOT1 PCIE 3.0 X8 OPROM
Use this feature to select which firmware to be loaded for the add-on card in this slot. The
options are Disabled, Legacy, and EFI.
JMD1:M.2-H OPROM/JMD2:M.2-H OPROM
Use this feature to select which firmware to be loaded for the add-on card in this slot. The
options are Disabled, Legacy, and EFI.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unified Extensible
Firmware Interface) for network stack support. The options are Disabled and Enabled.
*If the feature above is set to Enabled, the features below will be available for
configuration:
Ipv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and Enabled.
Ipv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. The options are Disabled and Enabled.
Ipv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and Enabled.
79
Advertisement
Table of Contents
