Installation - Hitachi EP-A9000 Instruction Manual

5
Install the water tank to the unit
Wipe off water drops in the water tank holder (inner part)
during installing the water tank.
Securely install the tank, making sure that it is pressed
until the back of the unit.
If it is not securely installed, it may cause water leakage
during operation.
Also, hold down the unit to make sure that the unit will not
move during installation.
CAUTION
The water tank may be heavy when filled with water. Be
careful not to injure your fingers, nails, or your back
while handling.

Installation

 A caster is attached at the base of the unit, thus it should be set on an even, stable and sturdy fl oor.
(No stopper attached to the caster)
 Avoid places near heating or cooling equipment and other similar equipment, and choose a location with a good air
circulation.
 Keep the rear at least 3cm away from the wall. Depending on the operating environment, walls or fl oors near the
outlet may be stained as the unit draws in air. If this is a concern, move it from its current location and clean the sur-
rounding walls and fl oors regularly.
*Air inlet and outlet must not
be covered by curtains or
furnitures
Leave space*
 Be careful not to pull or pinch the power cord.
 Leaving the unit at the same place for an extended period of time may leave stains on the walls and fl oors.
When cleaning the unit, move it to another place and also include cleaning the fl oor.
 Do not place on shelves, desks, tables or other similar places
Unit may fall due to vibration or tilting, and may cause injury, water leakage and electric shock.
 Using the unit in a tilted state may cause water leakage.
 Moving the unit with the caster can be done on a sturdy and even fl oor. To move the unit on a mat,
carpet, or places with uneven surface, carry the unit by its handle.
CAUTION
At least 3cm
Leave space*
WARNING
Water tank holder
Water tank
E-17