Installation - Hitachi EP-A8000 Instruction Manual

Table of Contents

Advertisement

Installation

Install the unit on a level, stable and sturdy surface.
Avoid any location close to cooling or heating appliances, and select a well-ventilated area.
Keep the unit at least 90 cm away from the walls on both sides. Otherwise, discharged air will mix with
surrounding air and the walls may become dirty.
Do not place the unit on an unstable floor or pedestal.
WARNING
Otherwise the unit may fall or drop, resulting in damage or unit failure.
Using the unit positioned on an angle may cause water to leak.
Hold the tip of the flap with your hand and adjust it.
The angle of the flap is adjustable in three stages.
When in operation, use it in a diagonal or upward direction.
Position of the flap
Closed (when not in operation)
Flap
When not in operation, close the
flap to avoid dust ingress.
When in operation, set it in a
diagonal or upward direction.
When changing the angle of the flap, move it until it clicks.
CAUTION
Do not operate with the flap closed.
Doing so may result in louder noise and greater vibration or failure.
Do not apply excessive force to the flap.
Doing so may result in failure and damage.
Do not move the body by holding the flap.
Damaging or dropping the unit may result in unexpected injury.
Opening the flap
Diagonal direction (in pollen mode)
Wind direction
Flap
Incline the airflow by the flap to
improve the capture efficiency
of pollen floating near the floor.
Use in pollen mode.
CAUTION
Flap
Upward direction
Wind direction
Flap
Normally use in the
upward direction.
E-13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents