Filling Water Tank - Hitachi EP-A9000 Instruction Manual

Preparations for Operation

Filling Water Tank

1
Remove the water tank from the unit
Grab the water tank handle, and while slightly
lifting it, gently pull the water tank.
CAUTION
When removing the water tank from the unit, pull the water
tank gently while pressing down the unit since a caster is
attached on its base. (The caster does not have a stopper)
2
Remove the tank cover from the water tank
CAUTION
Be careful not to injure your finger or nails when
removing the tank cover.
Make sure that the water tank filter is not subject to
unnecessary force. If damaged, it will not be able to
pump up water.
3
Rinse the water tank and tank cover with water
and check the movement of the float switch.
Rinse in running water for 2-3 times.
Do not use detergent.
Check if the float switch can move up and down.
Do not to remove the float switch, or subject it to
unnecessary force.
Otherwise "Water Refill" will not be detected.
4
Put water in the water tank and place
the tank cover.
Fill the water tank, making sure that it does not
exceed the line.
Wipe the moisture around the water tank.
When filling the water tank away from the unit, attach
the tank cover and hold it in place.
If the water exceeds the fill line of the water supply, it
may cause water leakage.
Securely attach the tank cover.
If it is not securely attached, it may cause water leakage
during operation.
E-16
(When Running on "Humidify" and "Skin Moisture" Modes)
CAUTION
CAUTION
(Continued)
Water tank filter
Tank cover
Float switch
Make sure that the water
does not exceed the line.
Water tank
Handle
Tank cover
Water tank
Water tank
Water level
Tank cover
Water tank