Table of Contents
Advertisement
Appendix D - HeatShift
WARNING
A l l F O U R ( 4 ) t a k e o f f s M U S T B E
C O N N E C T E D T O P L E N U M ( S ) .
Install Duct Termination Plates (LKD7)
—see previous page for LDK1, LDK3 & LDK4
Plenum kits
1. Frame a rough opening and platform at the desired
location—see earlier sections of this manual for al-
lowable duct termination plates positions and rough
frame opening sizes.
2. On each duct termination plate, rotate both stand-
o s to the vertical position and secure in place using
screws provided.
2 stand-offs per plate
3. Install the termination plates into the framing ensur-
ing collars/pipes on underside of plates maintain
1 inch clearance to combustibles and clearance to
combustible above the plates are maintained as
listed on page 13.
The termination plates perimeter may be trimmed
as necessary to accommodate framing. Secure the
termination plate to framing using screws or nails to
avoid movement.
84
Installation
®
4. Attach one section of UL-181, Class 1 approved air
duct to each of the collars and secure it with gear
clamps provided. DO NOT SPLICE DUCTS!
5. Attach the top of the pipe sections to the duct ter-
mination plates securing them with the gear clamps
provided. An upward slope must be maintained in
horizontal sections of pipes for proper convection.
Use straps as necessary to maintain the pipes posi-
tions. Support horizontal sections every 24 inches.
6. Continue with the replace installation.
Repair Parts List
Description
LDK1
48" Quad Hot Air Plenum Kit
48" x 2" quad plenum
5" take-off collars (4)
Top mounting bracket/standoffs
#8 slotted drive screws 1/4" (7)
LDK2
48" Outlet Frame Kit for LDK1
Aux Frame-SPL 48" x 2" white
LDK3
14" Double Hot Air Plenums Kit
14" x 6" double plenums (2)
5" take-off collars (4)
DABL-00-C-SPL 14" x 6" Grilles white (2)
Top mounting bracket/standoffs (2)
#8 slotted drive screws 1/4" (6)
LDK4
38" Quad Hot Air Plenum Kit
38" x 2" quad plenum
5" take-off collars (4)
Top mounting bracket/standoffs
#8 slotted drive screws 1/4" (7)
LDK5
38" Outlet Frame Kit for LDK4
Aux Frame-SPL 38" x 2" white
LDK6
5" Aluminum 2-ply Flex Kit
5" dia 10' (uncompressed) aluminum
chimney liners (2)
4.5" - 6.5" ss gear clamps (8)
LDK7
Duct Termination Plates
Plate and collar assembly (2)
5" take-off collars (4)
Screws 8 x 3/8 tap PN HD PH (12)
Each LDK kit is sold separately.
Part no.
4005476
4005478
4007211
798601
4005612
4005464
4005478
4005614
4005566
798601
4005477
4005478
4007213
798601
4005613
4005635
4005642
4006747
4005478
100A757
Advertisement
Table of Contents
