Installation
7. Align the molex connection on the switch cable of
the harness assembly and connect to switch.
8. Mount the switch plate to the junction box with
2 screws provided. Note: Place the switch left or
right to suit the homeowner wishes.
9. Locate and secure the magnet plates using 2 'long'
screws provided.
32
Remote Battery & Wall Switch Kit
10. Place and secure the
cover plate to the box us-
ing 4 screws provided.
11. Feed the cable tie through the 2 side slots of the
battery cover assembly.
12. Position the battery holder to the rear face and
secure together with a cable tie. Note that clear-
ance is required for battery snap connection.
Cable tie
Snap connector
13. Make the snap connec-
tion, load 4 AA alkaline
batteries into the holder
(included with fi replace)
then feed back into the
junction box assembly.
Note: Do not put batter-
ies in the receiver, only in
the battery holder by the
wall switch.
14. Test the operation of the wall switch—see Appendix.
Side slot
Rear view
Front view