Table of Contents
Advertisement
Stainless Steel Main Top
Lift away pots or pans from main top. Remove grates from
spillage area and carefully place in a sink of warm soapy
water. Wipe loose debris from main top. Avoid using any
abrasive cleaners including cream cleaners on brushed
stainless steel surfaces. For best results use a liquid detergent
cleaner. Rinse with cold water and thoroughly dry with a
clean, soft cloth. Ensure all parts are dry before repositioning.
Avoid using any abrasive cleaners including cream
n
cleaners on brushed stainless steel surfaces.
Never use caustic or abrasive cleaners as these will
n
damage the surface.
Control Panel and Oven Door
The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth.
The oven door should only be cleaned with a soft cloth
wrung out in clean, hot soapy water.
Removing the Oven Door
The oven door can be removed for ease of cleaning.
Open the oven door fully and release the saddle brackets
situated either side (Fig. 5.3). Ensure that the saddle brackets
are opened to their end positions, to prevent the hinges from
retracting into the oven door.
Close the oven door until it is half closed then carefully lift
and un-hook the door panel from the range (Fig. 5.4).
To re-assemble, ensure that the saddle bracket and hinge
mechanisms are correctly positioned (Fig. 5.5).
Carefully replace the door panel using the hinge locating
notches, open it fully then close the saddle bracket (Fig. 5.6).
DO NOT use harsh abrasive cleaners or sharp metal
n
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.
Oven Door Gasket
Avoid cleaning the oven door gaskets. If you need to remove
a build-up of food or grease follow these procedures:
Dampen a sponge with clean hot water and gently wipe the
debris from the affected area. DO NOT rub.
Press a dry towel gently on the gasket to dry.
DO NOT use any abrasives or cleaners on the gasket.
n
2
13
Fig. 5.3
Fig. 5.4
1
Fig. 5.5
Fig. 5.6
notch
Advertisement
Table of Contents
