Table of Contents
Advertisement
7.1
Assembling the bed
Mounting instructions:
• The assembly of the bed must be carried out by a minimum of two persons;
Figure 1: connecting the mattress platforms
1. Use the bars provided to connect the mattress platforms together (figure 1) ensuring the end
of each bar with the blue dot is inserted first into the fame with the matching blue dots. Also
note the location holes for the hand screws need to be on the bottom of the connector bars
(figure 2) as shown in the photo above right
2. Once the two halves of the frame are fully pushed together, hand tighten all the hand screws.
Figure 3: Connecting bars being pulled out to 90 degrees
3. Unscrew the 4 hand screws on both ends of the frame.
4. Swing the connecting bars outward to 90 degrees (figure 3).
5. Align the footboard which has the longer connector bars with the footend of the mattress
platform and push the two parts together (figure 4)
6. Tighten all the turn hand screws
7. Repeat actions 3 to 5 on the opposite side
Issue 3: 20/04/20
Figure 2: Blue dots and location holes
90 degrees
Figure 4: Footboard and platform connected
Connector
Turn hand screw
Page 13 of 32
Advertisement
Table of Contents
