Related Manuals for Ultimate Healthcare UBEE0001-2
Summary of Contents for Ultimate Healthcare UBEE0001-2
- Page 1 Mattress Elevator UBEE0001-2 Read instructions completely before using the Ultimate Healthcare mattress elevator. User Manual Issue 2: 17/08/2017...
-
Page 3: Table Of Contents
Troubleshooting Technical specifications and warranty Introduction Designed in the UK, Ultimate Healthcare’s Mattress Elevator is adjustable and suitable for single and double beds measuring from 76cm to 152cm wide (2’6” to 5’). Electrically powered, the mattress elevator provides postural support allowing the user/users to sit up unaided at the touch of a button. -
Page 4: Dos And Don'ts
Dos & Don’ts • DO ensure the instructions are fully read and understood. • DO retain the instructions with the mattress elevator. • DO ensure the mattress will flex profile sufficiently (bend to 72˚). • DO ensure the bed base is of suitable strength and rigidity. •... -
Page 5: Assembly And Fitting 3
Prior to installation, ensure your mattress elevator is suitable for your local supply, i.e. 230 Volts 50Hz and UK 3-pin socket (BS1363) Ensure that the bed to which the Ultimate Healthcare mattress elevator is fitted has a base of suitable strength and rigidity to support the product. - Page 6 Assembly and fitting, continued: Replace the mattress with the bed sheet fitted onto the bed base and mattress elevator. Secure the mattress elevator upper section to the mattress using the single black strap around the width of the mattress. Ensure the strap is tensioned sufficiently.
-
Page 7: Instructions For Use
Connect both transformer cable and hand controller cable to the two mattress elevator leads attached to the actuator (motor). 10. Having ensured the power cables are routed safely towards the head end of the bed, insert the mains lead into the power supply. Then, insert the mains plug into the power socket. -
Page 8: Parts List
Maintenance Inspect the mattress elevator daily. Ensure that the securing straps are under tension and the frame is positioned correctly on the bed. Check the frame, straps, power leads, transformer and hand controller for any signs of wear/damage. If parts are found to be defective or worn, do not use the mattress elevator. Seek assistance from your supplier or contact Customer Services on 0870 428 6295. -
Page 9: Troubleshooting
7 4 x Clips Troubleshooting Please note the mattress elevator does not contain any user serviceable components. Do not disassemble any components. In the event of failure, refer to your supplier. In the event the mattress elevator fails to operate, complete the checks listed below: First ensure the metal framework (mechanism) is not obstructed. -
Page 10: Technical Specifications And Warranty
Technical specifications Single/combined maximum user weight – 254kg (40.5 stone) Safe working load - 313kg (49 stone) Suitable for bed widths 76cm – 152cm (2’6” – 5’) Backrest angle variable – 10˚ to 70˚ Maximum duty cycle 10% (6 minutes usage per hour) Mattress Elevator net weight - 16kg Transformer: Linak... - Page 11 Issue 2: 17/08/2017 MILLBROOK INDUSTRIES LTD...
- Page 12 Ultimate Healthcare, Calmore Industrial Estate, Nutwood Way, Totton, Southampton, Hampshire. SO40 3WW Tel: 0333 321 8996 Email: info@ultimatehealthcare.co.uk Issue 2: 17/08/2017...