Ultimate Healthcare Tamora Plus II Quick Reference Manual

Tamora Plus II
Quick Reference Guide
This Quick Reference Guide (QRG) has been produced to assist users with only the functional aspects of the system.
Please refer to the product User Manual for full instructions for use.
Function Mode Button
• Pressing the Mode button allows you to cycle
between the different modes available such as
Alternating and Static.
• It also allows you to select Alternating cycle
times.
Control Panel Lock Out
To unlock panel:
• Press & hold for 3 seconds to unlock control panel.
To lock panel:
• To lock out the control panel press the Lock Out
button and all functions will be locked.
• If the control panel is not used for a period of 30
seconds it will automatically lock out and inhibit
the use of the functions.
Comfort Control
The comfort level adjustment dial allows adjustment of pressures
within a safe pre-set range.
• When the dial is turned towards
Firm, the output pressure will increase
to provide a higher pressure output
and thus increased support.
• When the dial is turned towards
Soft, the output pressure will
be decreased to provide a lower
pressure output and thus increased
comfort.
Alternating Mode
• Alternating mode is the default mode for the
• Alternating cycle will continue at the selected
cycle time until another mode is selected.
Alternating Cycle Time Selection
• Choice of 10/15/20 minutes
To select press Mode button until the relevant
•
indicator light is illuminated next to desired cycle
time selection.
Static Mode
• Pressing the Mode button until the Static indicator
illuminates puts the system into Static mode.
• After 30 minutes the system will automatically
revert back to Alternating mode.
Transport Mode
Transport mode will maintain the cells in their present state for
approximately 48 hours.
• Simply disconnect air pipe connector
and place the connector cover over
it. The air pressures in the mattress
will now equalise, but maintain a
degree of comfort.
• It is important to restore the mattress
as quickly as possible by reconnecting
the supply tubes to the power unit.