ADA INSTRUMENTS 6D SERVOLINER GREEN Operating Manual page 5

2. It is possible to use charger to operate with the instrument. Use
charger for rechargeable batteries. Connect the charger to the hole
that is located on the housing of the line laser. Then connect it to the
main power. The line laser is in working condition and rechargeable
batteries are charging.
WARNING: Never use charger for ordinary batteries. Do not
leave the line laser unattended while using charger. Parameters
of the charger must correspond to the parameters of domestic
electricity. Output voltage must be no more than 6V.
3. Set up the lione laser on the floor or the tripod. When using tripod,
screw the tripod screw into the centering hole.
4. Press button (1) to switch on the line laser. Press buttons H (7) and
V (5) to switch and select vertical and horizontal lines. Switch off the
unnecessary lines to save battery power.
Variants of projections:
H button:
- 1 horizontal line (sector 120º)
- 2 horizontal lines (sector 180º)
- 4 horizontal lines (sector 360º)
V button:
- one vertical line and plumb down
- two vertical lines and plumb down
5. Switch On the line laser. If the LED is light and the laser beam begins
to blink, the deviation of the line laser from the horizontal plane is
more than ±3º. Adjust the line laser with the he;p of adjustable legs.
6. Place the line laser on the floor or tripod. When using tripod, screw
the tripod screw into the centering hole. Aim the plumb down on the
object on the floor. Then adjust the line laser with the help of fine
adjustment switch. Rotate the upper part of the line laser to adjust
the vertical lines.
5
English