Before Starting Of The Burner It Is Necessary - Orlanski ORLIGNO 100 Manual And Service Manual

5.5. Before starting of the burner it is necessary:

1. Check installation condition.
2. Fill in pellet to the tank, cover with lid
3. Check if fuel contains any unwanted elements ( rocks, metal elements)
4. Screw in sensor's sleeve in one of two probes on the right side of boiler behind safety coil
5. Put the boiler sensor in to the sleeve
Feed time
Max air
Feed time
Max air
8. Feed fuel from tank till it show up in flexible pipe.
9. Turn off fuel feed and hold ON button.
10. When changing fuel ex. on oats; it is necessary:
- turn off boiler
- wait till boiler cool down
- remove pellet grate and clean surface
- put oats grate
- set feed time and max air amount acc. to chart
11. Burner maintenance after heating season:
- turn off and disconnect from power supply
- clean thoroughly
- remove pellet from tank
Pellet*
30% of power
1,5
8
OATS**
2
9
100% of power
5
13
7
14
25