Orligno 400 Package Assembly; Before Starting Of The Burner; Fuel Characteristics - Orlanski ORLIGNO 400 Instruction Manual & Service Manual

6. Orligno 400 package assembly

Mounting external equipment:
1. Attach burner plug to the burner socket (pic 1)
2. Assemble fuel tank acc. to enclosed manual.
3. Insert external feeder in to the tank:
4. Attach the elastic pipe between external feeder and the metal
connector. Tighten elastic pipe to feeder and metal connector with
clamp.
5. Make sure the elastic pipe is near vertical (no bends), so the pellets
drop directly into the hearth.
6. Attach the connector from the controller to feeder's motoreducer.
7. Fit the plug 230V to socket from the controller to the 230V socket.
7. Before starting of the burner it is necessary:
1. Check installation condition.
2. Fill in pellet to the tank.
3. Check if fuel contains any unwanted elements ( rocks, metal elements).
4. Connect burner's and feeder's plugs.
5. Turn on controller.
6. Feed fuel (SIMPLE MENU: Feed fuel: Yes) from the tank till it shows up on a burner.
ATTENTION!
Elastic pipe connected between burner and feeder must be under 45° angle so that pellets drops
feely to the burner!
7. Turn off fuel feed and hold
8. Fuel characteristics - recommendations
a) Pellet granulate made according to DIN 51731
- granulate 5-8 mm
- recommended calorifi c value 17500-19500 kJ/kg
- ash content 1,5%
- max moisture content 12%
- density 1-1,4 kg/dm³
8
ON/OFF
button - boiler starts automatic lightning up.
pic. 1