Starting Up; Operation For Tig Mode - Linde BOC Smootharc TIG200 DC Operating Manual

34 BOC Smootharc TIG 200 DC Operating Manual
IMPORTANT
Before you begin a welding operation, please press the torch switch
for a few seconds until all the air in the gas tube is removed.
WARNING
It is dangerous to connect or disconnect the gas hose or connector
whilst welding.
7.2

Starting up

Switch on the machine using the Power Switch. The panel will display
the previous settings that were saved in the last shutdown.
7.3

Operation for TIG mode

Set welding mode
Press the welding menu button on the front panel to choose the welding
mode. The machine enters TIG mode when TIG Indicator lights up.
Choose 2T (LIFT)/ 2T (HF)/4T (HF)/ Spot (HF) mode
Under the TIG welding mode, there are four modes: 2T (LIFT), 2T (HF), 4T
(HF) and Spot (HF). Press the welding menu buttonn for 3 seconds, and
then release to choose the mode, as shown in figures 1–4.
1. 2T (LIFT) mode
2. 2T (HF) mode
3. 4T (HF) mode
4. Spot (HF) mode