Auto Power-On Select; Backlight Power Select - DFI BW551 User Manual

Auto Power-on Select

1
2
JP6 is used to select the method of powering on the system. If you want the system to pow-
er-on whenever AC power comes in, set JP6 pins 2 and 3 to On. If you want to use the power
button, set pins 1 and 2 to On.
When using the JP6 "Power On" feature to power the system back on after a power failure
occurs, the system may not power on if the power lost is resumed within 5 seconds (power
flicker).
Chapter 2 Hardware Installation
Chapter 2
1 2 3
JP6
1-2 On:
Power-on via power button
(default)
1 2 3
2-3 On:
Power-on via AC power
1

Backlight Power Select

JP10 is used to select the power level of backlight brightness control: +3.3V or +5V.
Important:
Before powering-on the system, make sure that the power settings of JP10 match the
power specification of backlight control. Selecting the incorrect voltage will seriously
damage the backlight.
11
JP10
1 2 3
1-2 On: +3.3V
(default)
1 2 3
1
2
2-3 On: +5V
1
www.dfi.com