Rear Panel I/O Ports; Dc-In - DFI BW551 User Manual

Rear Panel I/O Ports

USB 3.0
LAN 1 LAN 2

DC-in

The rear panel I/O ports consist of the following:
• DC-in connector
• 2 GbE (RJ-45)
• 4 USB 3.0 ports
• 1 VGA port
• 1 DP++ port
Chapter 2 Hardware Installation
Chapter 2
VGA
DP
13
12V DC-in
DC-in
1 3
12V2
GND1
12V1
GND2
2 4
This jack is considered a low power solution. Connect a DC power cord to this jack. Using a
voltage more than the recommended range may fail to boot the system or cause damage to
the system board.
The 4-pin right-angle connector on the system board co-lays with a DC-in jack (optional) or
4-pin vertical type connector (optional) as the photo displayed below.
4-pin Right Angle
(default)
1
2
1
4-pin Vertical Type (optional)
DC-in (optional)
www.dfi.com